OMCP
SKU
OMCP
Click to get a shareable link to current item config
Copied to Clipboard
High Temp Vinyl Insertion Plugs (OMCP)
MOCAP High Temperature Vinyl Plastic Masking Plugs are a low cost quality answer to your masking needs. Flexible material allows these plastic plugs to seal threaded and non-threaded openings. Special high temperature resistant vinyl material withstands up to 446°F(230°C).
For more information, see our OMCP Series page.
Additional Information
NOTE: Due to the inherent variability of the dip-molding process, the "Flange OD" may vary by +/-1.6mm (1/16") from the figures shown above.
Wall thickness is measured approx. 6.35mm (.25 inch) from open end. Wall thickness increases slightly towards the closed end of the part
Micropacks are only available for purchase through our online store.
MOCAP High Temperature Vinyl Plastic Masking Plugs are a low cost quality answer to your masking needs. Flexible material allows these plastic plugs to seal threaded and non-threaded openings. Special high temperature resistant vinyl material withstands up to 446°F(230°C).
For more information, see our OMCP Series page.
NOTE: Due to the inherent variability of the dip-molding process, the "Flange OD" may vary by +/-1.6mm (1/16") from the figures shown above.
Wall thickness is measured approx. 6.35mm (.25 inch) from open end. Wall thickness increases slightly towards the closed end of the part
Micropacks are only available for purchase through our online store.